The ruling
Not easily, but it is still steel. Colorbond is steel with a metallic coating and baked paint; Zincalume is the same coated steel left bare. Corrosion starts where something holds water against the sheet, and small rust spots are often steel filings. The colour softens with weathering, and painting it voids BlueScope's warranties.
Zincalume or Colorbond: what each one is
Both are BlueScope steel. Colorbond is built in five layers: a steel base, a metallic coating, a thin pretreatment so the next coats bond, a corrosion inhibiting primer baked on, and an exterior grade topcoat baked on over it.1 Zincalume is the steel with its aluminium, zinc and magnesium alloy coating and no paint.2 It leaves the factory with a clear resin on the surface so fingerprints do not mark it during installation.3
The metallic coating is what protects the steel from rust. BlueScope's current coating, which it calls Activate technology, is an aluminium, zinc and magnesium alloy, designed for better corrosion resistance than an aluminium and zinc coating. The magnesium helps the coating give itself up to protect exposed steel and form a tougher barrier.4 Near the sea, BlueScope recommends Colorbond steel for a roof more than 200 metres from breaking surf, and Colorbond Ultra between 100 and 200 metres.5
In plain terms Zincalume is the bare silver sheet. Colorbond is that same kind of sheet with a factory paint job baked on top.
Does it rust?
Not easily, and not everywhere. BlueScope's roof warranty is written against "corrosion to perforation", rust right through the sheet, over a period set by how the roof is used and where the house is.6 Its bulletins say where corrosion starts. In unwashed areas, dust and dirt absorb condensation and can start it.2 Under solar panels, dirt, salt and leaves that hold moisture can bring on accelerated corrosion, and ponded water gives the steel an extended period of wetness.7 Materials that hold moisture against the sheet matter because "Extended time of wetness can be a major influence of corrosion mechanisms."8 Fasteners that deteriorate can bring on corrosion of the sheet right around them, and BlueScope says to consider replacing any showing red rust.2
The warranties draw the same line, for Colorbond and Zincalume alike. They do not cover corrosion due to a "failure to remove debris" or to allow free drainage of water, contact with "moisture retaining substances", or contact with copper and other dissimilar metals. Both also class white corrosion products and red rust on cut edges as aesthetic surface corrosion, which they do not cover.6, 9 Moss can hold many times its own weight in water10, which is why growth belongs in this conversation, as can moss and lichen grow on a metal roof explains.
Small red brown spots are often not the roof at all. They are swarf, steel filings from cutting and drilling, rusting on the surface. A fresh swarf stain is a small red brown patch with a dark spot in the middle and feels like sandpaper. BlueScope says these stains are often mistaken for early deterioration, and on Colorbond are generally only cosmetic; on bare metallic coated steel, swarf can cause accelerated corrosion over a small area.11 Minor scratches under 2 mm wide that cannot be seen from the ground are best left alone, because the metallic coating protects the steel.3
In plain terms Steel roofing does not rust from the rain falling on it. It rusts where something stops it drying out.
Does it fade?
Yes, slowly and evenly, and BlueScope expects it. After one to two years in service Colorbond typically has a uniformly weathered surface, with a slight loss of gloss.3 Its warranty calls a natural reduction in gloss and a natural colour change of the paint normal weathering, and does not cover it.6 The baked on topcoat is there to make the finish keep its look for longer.1
Darkening is something else. On lighter coloured roofs, very heavy growth can change the overall colour and appearance, and BlueScope's spot test tells growth from dirt: a drop of fresh bleach on a dark patch comes up clean if it is fungus.12 BlueScope says touch up paint weathers differently from the baked finish, so touched up areas can leave a blotchy look.5
In plain terms Fading is weathering, and it comes on evenly across the sheet, not in patches. A roof going darker, or darker in patches, is often something living on it, and the bleach test says which.
Can you paint it, and does it need it?
It can be painted. BlueScope says Colorbond, Zincalume and galvanised steel "can be successfully overpainted", but that air drying paints weather differently and often do not match the durability of the baked finish, and that "The overpainting of COLORBOND® steel, ZINCALUME® steel or zinc-coated steel will void any warranties issued by BlueScope."3 On a roof that feeds a rainwater tank, the paint must be recommended by its supplier for collecting drinking water.3 Roof restoration or roof treatment weighs up coating a roof against treating what is growing on it.
Does it need painting? Not by the steel maker's guidance. BlueScope's upkeep for a roof is the rain, plus washing where the rain does not reach.13 Lysaght's maintenance for a roof covers regular inspection, washing down, and clearing leaves and debris from the gutters and downpipes.14 Neither lists painting.
In plain terms Painting a Colorbond roof is like repainting a new car by hand. It can be done, it will not last like the factory finish, and the maker stops standing behind it.
How long does it last, and when is it time to replace?
BlueScope does not publish a single lifespan. Its warranty period is set by the end use and the location of the house5, and Lysaght says that of a roof's design, its environment and its maintenance, "Maintenance is probably the biggest factor."14 Hail dents generally do not shorten the life of a Colorbond roof, BlueScope says, unless they are deep enough on a low pitched roof to pond water and dirt, or bend the sheet laps enough to draw water in.5
Growth is not a reason to replace a roof. BlueScope says fungus, mould and lichen on its steel can be removed with the appropriate cleaning agents5, and its warranty is written against two failures: corrosion through the sheet, and the paint flaking or peeling.6 Keeping growth and debris off the sheet is part of avoiding the first.
In plain terms A roof is replaced for holes, not for stains. Keeping it clear is part of keeping the holes away.
What this means for your roof
A steel roof rusts where something holds water against it, and moss and the debris it traps do exactly that. Its colour softens with the weather, and that is normal; a roof going darker is often growth, and growth comes off. We treat Colorbond and Zincalume roofs with UNGROW Bailiff, the same way as tiles: it ends the growth where it sits, and the weather carries it off. It goes on from the roofline at low pressure, so nobody walks the sheets, and BlueScope warns that foot traffic can dent, scuff or scratch them7; the steel maker's own cleaning guidance is in how to clean a Colorbond roof. Run the Roof Report to see which faces of your roof stay wet longest, and put your address in below for a fixed price.
Also asked
Is a Colorbond roof steel or aluminium?
Steel. Colorbond is a steel base with a metallic coating, a pretreatment, a primer and a baked on topcoat. The metallic coating on BlueScope's current steel is an aluminium, zinc and magnesium alloy, which is where the aluminium comes in. What many people call a tin roof is steel too, whether it is galvanised, Zincalume or Colorbond.
Can I touch up scratches on Colorbond?
BlueScope does not recommend touch up paint. Air drying paint weathers differently from its baked finish, so touched up areas end up looking different and can leave a blotchy look, and overpainting voids BlueScope's warranties. Minor scratches under 2 mm wide that cannot be seen from the ground should be left alone, because the metallic coating underneath protects the steel. If scratches on new sheets are more noticeable than that, BlueScope recommends replacing the sheet.
Do Zincalume and Colorbond clean the same way?
Mostly, with two differences. BlueScope says the solvent cleaners it bans from prepainted steel, and sugar soap as well, must not be used on bare Zincalume. And acidic products must not be used on Zincalume or galvanised steel, because excessive staining and corrosion will occur. Fresh water, mild detergent, a soft brush and a thorough rinse suit both.
How long does a Colorbond roof last?
BlueScope does not give one number. Its warranty against corrosion through the sheet runs for a period it sets by the end use and the location of the house, and near the sea it recommends Colorbond Ultra between 100 and 200 metres from breaking surf. Lysaght says that of design, environment and maintenance, maintenance is probably the biggest factor in how long a roof lasts.
On the record
- BlueScope (COLORBOND steel), Five Layers of Protection
- BlueScope, TB-4 Maintenance of exterior BlueScope coated steel products (2026)
- BlueScope, TB-2 Overpainting and restoration of exterior BlueScope coated steel products (2022)
- BlueScope (Steel Select), Durable Performance of COLORBOND steel
- BlueScope (COLORBOND steel), Frequently Asked Questions
- BlueScope, COLORBOND steel when used in the manufacture of roof sheets in Australian applications (sample warranty) (2026)
- BlueScope, TB-36 Guide to good practice: steel roofing and photovoltaic/solar panels (2025)
- BlueScope, CTB-17 Following trades (2022)
- BlueScope, ZINCALUME steel when used in the manufacture of roof sheets in Australian applications (sample warranty) (2026)
- Australian National Botanic Gardens, Bryophyte ecology
- BlueScope, TB-5 Swarf staining (2022)
- BlueScope, TB-27: Identification of fungus in the field and recommendations for its removal (2022)
- BlueScope (COLORBOND steel), Easy to Maintain
- Lysaght (BlueScope), Roofing & Walling Installation Manual