The ruling
Once properly, then a top up whenever growth starts to return. Spores land on every roof all the time and the treatment slowly leaves the roof, so growth recurs. The first treatment is the hard one, ending years of growth. After that, keeping a clear roof clear is routine, and shaded roofs come round sooner.
Why growth recurs
Every roof is being sown all the time. Lichen fungi make spores small enough to ride the slightest breeze, and lichens also shed soredia and isidia, tiny packets carrying both partners, while any fragment broken off a lichen can grow into a new one.1 In most mosses and their relatives the spores travel by wind.2 Monier, which makes roof tiles, puts it simply: moss and lichen spores "can settle on roofing materials where moisture and dirt accumulate".3
No treatment changes what lands on a roof. What it changes is what is living there now.
In plain terms A roof is a garden bed. The seed rain never stops, so the question is never whether weeds arrive. It is how long you let them stay.
Why a top up keeps it clear
A treatment ends what is living on the roof on the day, and over the months after, the treatment itself breaks down on the roof. In a pilot study that followed treated roof sections on concrete and clay tiles for a year, a mass balance showed a large part of the benzalkonium chloride applied was lost from the tiles, which the researchers put down to microbes breaking it down.4
New growth also moves in from around the roof. On engraved sandstone in northern Italy, cleaned, treated and monitored for 54 months, biocides applied after cleaning gave the best results through two growing seasons, and regrowth came mainly from the uncleaned surfaces around the treated patches. In the shadier zone, mosses and a dark cyanobacterial film came back quickly.5 That is why every face is treated, and why shaded roofs come round sooner.
In plain terms Treating a roof is weeding a garden. It clears the bed, the seed keeps falling, and a top up is the next weeding.
Why the first treatment is the hard one
The first treatment meets years of growth: thick cushions of moss, crusts that have been creeping outward for years, and a biofilm along every lap. Crust lichens are the slowest growing lichens of all6, and most mature leafy lichens spread 1 to 5 mm a year across their radius7, so a colony the size of a saucer has been there a long time.
Those years are not idle. On clay roof tiles six to ten years old, electron microscopy found lichen threads penetrating the tile and filling its fissures and cracks8, and lichen fungi excrete oxalic acid, which dissolves minerals in the surface they grow on.9 More in does lichen damage roof tiles?
Heavy growth is harder work. The Surrender label tells you to clean off a heavy infestation and apply again10, and Wet & Forget allows a second application a month after the first on a badly contaminated surface.11
A roof that stays treated never builds that load again. Whatever settles between top ups is young and thin, on a surface that has not been roughened by blasting or worked on by years of lichen. That is why the first treatment is the hard one, and the upkeep after it is easy.
In plain terms The first mow of a lawn left for a year takes all afternoon. The mow after that takes twenty minutes.
What staying treated looks like
We treat the roof with UNGROW Bailiff, photograph it on the day and check it against that photo at twelve months. If it looks the same, we treat it again with Bailiff, free. After that, we get in touch about a top up with UNGROW Sentry, our preventative, at around two years, and whether it is due then depends on the roof: shade and trees bring it round sooner, an open, sunny roof later.5 A Colorbond or other metal roof can come round sooner too. It is treated the same way and clears the same way, but smooth painted steel holds less of the treatment than a porous tile, so its Sentry top up is often due earlier, and we keep it on that rhythm. We also have roofs in field testing that were treated three and a half years ago, with nothing done since, and they are still looking great.
A pressure clean does not buy a longer gap. It takes growth off by force and takes surface with it. Monier, which makes roof tiles, "strongly advises against the use of pressure washers for roof cleaning"3, and Marley, the UK tile maker, says a high powered jet wash "can damage the surface of the slate or tile, thus reducing its expected life considerably".12 In lab tests on cement mortars, how fast growth fouled the surface was governed by its roughness and porosity13, so a roughened roof gives the next spores a better start. More in does pressure cleaning damage roof tiles?
In plain terms Staying treated is like spraying weeds. Nobody takes an angle grinder to weeds, and a pressure cleaner is the angle grinder: it takes the weeds and a layer of the path with them.
What to watch for
The early signs are small, and they show in the same places the growth started last time.
- A film on the shaded faces. Bacteria, algae and fungi settle on tiles first as a biofilm, which in time turns into black or green spots.14 In Australia the sun's path is to the north15, so look at the south faces and anything under a tree first.
- Small spots of lichen. Flat, crusty, stuck to the surface rather than sitting on it. Colour will not tell you much. Texture will.
- Moss in the valleys and gutters. Gutters, downpipes and valleys build up with leaves and twigs, and once they block, water builds up and overflows back into the roof.16 On the roofs we treat, that is where moss shows first. Monier recommends trimming overhanging branches to cut the debris.3
In plain terms Look where a garden path goes green first. The side that stays damp and shaded longest, and the corner where the leaves pile up, show it before anywhere else.
If you are not sure what you are looking at, lichen, moss, algae or mould tells them apart by form and texture.
What this means for your roof
Growth will land on your roof again, so what matters is when it gets caught. Caught early, it is young, thin growth on a sound surface, and a top up of Sentry from the roofline ends it where it sits. Left for years, it anchors into the tiles and packs the valleys, and the next treatment is a first treatment all over again. We apply Bailiff from the roofline with a low pressure soft wash pump through non-directional nozzles, photograph the roof on the day, and check it against that photo at twelve months.
Also asked
How often should you clean your roof?
As often as growth starts to come back, and the roof sets that, not the calendar. Spores land on every roof, and shaded faces and roofs under trees grow back sooner than open, sunny ones. Cleaning moss and lichen off a roof is a treatment, not a scrub: UNGROW Bailiff ends the growth where it sits, and it weathers off over the following months. Then a top up with UNGROW Sentry, our preventative, keeps it clear. The first clean is the big job; the rest are routine.
How long does roof moss treatment last?
The clear roof lasts until new spores take hold, and the roof sets that, not a number of years: shade and trees bring it round sooner, an open, sunny roof later. Our field test roofs were treated three and a half years ago, with nothing done since, and they are still looking great. A top up with UNGROW Sentry, our preventative, keeps it clear after that: see how do you stop moss growing back on a roof.
Do I need to treat the roof every year?
No. A treatment is not a yearly ritual. We check the roof at twelve months against the photo from the day, and we get in touch about a top up with UNGROW Sentry, our preventative, at around two years. Our field test roofs were treated three and a half years ago, with nothing done since, and they are still looking great. Shaded roofs under trees come round sooner than open, sunny ones.
Can I stop it growing back for good?
You keep it clear by staying on top of it. Spores land on every roof, every year, so a top up with UNGROW Sentry, our preventative, catches new growth while it is young and thin on a sound surface, instead of late on a damaged one. Staying treated is what resolves it.
Does a Colorbond roof need treating more often?
It can need its top up sooner. We treat Colorbond and metal roofs with UNGROW Bailiff, and it works the same way as on tiles: it ends the growth where it sits, and the weather carries it off. Smooth painted steel holds less of the treatment than a porous tile, so the top up with UNGROW Sentry, our preventative, can come round sooner on a metal roof. Staying treated is what keeps it clear, and we keep each roof on its own rhythm.
Is a top up cheaper than the first treatment?
It is less work, so yes. The first treatment, with UNGROW Bailiff, deals with years of build up. A top up with UNGROW Sentry, our preventative, deals with young, thin growth on a roof that is already clear. Routine work at a routine price. Like every job, it is priced off the address from aerial imagery, at a fixed price.
Would a pressure clean last longer?
No. A treatment leaves the tile surface whole, and a smoother surface is slower to foul. A pressure clean takes growth off by force and takes surface with it: Monier strongly advises against pressure washers for roof cleaning, and Marley says a high powered jet wash can damage the surface of the tile and shorten its life. On a rougher surface the next spores get a better foothold.
What is the first sign it is coming back?
Usually a faint green or dark film on the south faces and under trees, or small spots of lichen, flat and crusty, starting near the edges and laps. Moss tends to show first in the valleys and along the gutters, where water and leaves sit.
On the record
- Australian National Botanic Gardens, What is a lichen?
- Australian National Botanic Gardens, What is a bryophyte?
- Monier, Roof cleaning and maintenance
- Water research, Benzalkonium runoff from roofs treated with biocide products - In situ pilot-scale study (2015)
- The Science of the total environment, Lithobiontic recolonization following cleaning and preservative treatments on the rock engravings of Valle Camonica, Italy: A 54-months monitoring (2023)
- Geografiska Annaler: Series A, Physical Geography, Growth of crustose lichens: a review (2010)
- NERC Open Research Archive, Growth of foliose lichens: a review
- Scanning, Evaluation of the effect of lichens on ceramic roofing tiles by scanning electron microscopy and energy-dispersive spectroscopy analyses (2005)
- Catena, Weathering of rocks induced by lichen colonization: a review (2000)
- Yates / Hortag, Surrender Mosskiller label (10 L)
- Wet & Forget Australia, Roof cleaning information
- Marley (UK), Can I clean or jet wash my roof tiles?
- The Science of the total environment, Bioreceptivity evaluation of cementitious materials designed to stimulate biological growth (2014)
- Microorganisms, Methyl Potassium Siliconate and Siloxane Inhibit the Formation of Multispecies Biofilms on Ceramic Roof Tiles: Efficiency and Comparison of Two Common Water Repellents (2021)
- Your Home (Australian Government), Orientation
- Monier, Monier Roofing FAQs