Case · On the day, and around the house

Lichen on solar panels

The ruling

Wash the glass with water and something soft, as the panel makers direct, and treat the roof around it. Lichen settles where water and dirt sit: the bottom frame, flat panels and shade. The tiles around the array grow the same lichen, and we treat those from the roofline, keeping the treatment off the panels.

Why lichen grows on glass

Glass looks too smooth and too clean to grow anything. It is not. Lichens take to surprising surfaces: the Australian National Botanic Gardens records one growing on clear polycarbonate roofing over a patio.1 On solar panels left out in São Paulo, a living film built up on the glass, and the share of organic matter in what covered the panels rose from 42% at six months to 58% at eighteen.2 It was a subaerial biofilm: dark fungi and pigmented bacteria were the main organisms, and algae and cyanobacteria were in it through the first year.2

Growth needs water and somewhere to hold. Monier's line about roofs applies to panels too: moss and lichen spores "can settle on roofing materials where moisture and dirt accumulate".3 On a solar panel, three things make that happen.

  • The bottom frame. On framed panels at a low tilt, water and dirt collect along the lower edge and leave what researchers call soiling bands. A survey of rooftop systems in central and eastern China found them widespread, even in Guangzhou, where about 1,800 mm of rain falls a year.4
  • Low tilt. Trina recommends a tilt of at least 10°, so rain washes the dust off and water drains, because water left sitting "could leave stains and negatively impact both the appearance and performance of the modules". Panels laid flat, it says, lack the "self-cleaning" of panels tilted at 10° or more.5 Across 186 systems in California, those tilted under five degrees lost more output to dirt.6
  • Shade. Shaded surfaces stay wet longest. On engraved sandstone in Italy, mosses and a dark cyanobacterial film rapidly recolonised the more shaded zone after cleaning.7 A panel shaded by a tree or a second storey is the one to watch.

In plain terms The bottom frame of a panel is a little dam. Every shower leaves a line of wet grit against it, and that line is where the lichen starts.

What it does to output

A solar panel makes power in proportion to the light reaching its cells, and a panel with shaded cells makes less.5 JinkoSolar puts it the same way: a build up of dust or dirt on the front face decreases output.8 The studies put numbers on it.

Study What was on the glass Loss measured
São Paulo, Brazil Dust plus a biological film 7% at 6 and 12 months, 11% at 18 months2
Central and eastern China Soiling bands along the bottom edge About 4.7% lower maximum current than its control system, June to October 20194
California, United States Dust through dry spells About 0.05% of efficiency a day on average, about 7.4% over a 145 day summer drought6

The São Paulo study shows what rain does and does not do. Heavy rain just before the twelve month sampling washed the larger loose particles away, yet the twelve month film carried almost ten times the fungal colonisation, and more organic matter. By eighteen months the loss had reached 11%.2 Rain cleans dust. It does not clean growth.

Growth does more than dim the glass. A patch that stays put shades the same cells day after day, and LONGi says partial obstruction "may even cause hot spots".9 Canadian Solar says power dissipated in shaded cells can cause "localized overheating, which in turn may negatively impact the module service lifetime".10 What that means for a panel's warranty is in does pressure washing void a solar panel warranty.

Trina gives owners a way to see what the dirt is costing: measure the current a heavily soiled string feeds the inverter, clean it, and measure again.11

In plain terms A patch of lichen on a panel is a small cloud that never moves.

What the panel makers say about cleaning

Two major panel makers publish their cleaning rules in their manuals. Your own panel's manual is the one that counts, but these are typical.

JinkoSolar8 Trina Solar5
Cloth and water A soft cloth, dry or damp. Tap water only on the glass, neutral rather than acidic or alkaline, and not high in minerals A dry or wet soft cloth, sponge or soft bristled brush, with household glass cleaner for greasy dirt
Chemicals Never, because they may affect the module's warranty and output No alkaline or strong acid solvents, such as hydrofluoric acid or acetone
Abrasives Never use abrasive material under any circumstances Tools must not wear the glass, and brushes must not be abrasive to it
Sharp tools and steam No sharp tools to wipe the glass, because they can scratch it Do not use a steam cleaner
When Early morning or late afternoon, when the panels are cool Not in the hottest part of the day, with water close to the panel's temperature
Junction box and connectors Keep oily substances, solvents and corrosive materials, herbicides among them, away Keep pesticide, herbicide and cleaning agent away
Standing on panels Do not stand or step on a module Do not stand on the modules to clean them

REC's cleaning guide sets the method out step by step. Wash the panels before they reach working temperature, early in the morning, with a garden hose at household water pressure. For stubborn marks, lightly wipe with a soft sponge, a microfibre cloth or a soft brush that is not abrasive, which may go on an extension pole. If soiling remains after rinsing, repeat the clean. On moss, mould and lichen growing on the back of its panels, REC says to clear the growth by hand or with a soft sponge, and that it "does not provide warranty for the application of any sprays or treatment".12

In plain terms Clean a panel the way you clean a car's windscreen, not the way you clean a barbecue plate.

Why gentle cleaning protects the glass

The glass on a panel is often coated. JinkoSolar calls for neutral water to avoid strong acid and alkali, "so as not to cause damage to the glass coating layer".8 Trina says cleaning tools must not wear the glass5, and its older manual's check after cleaning includes looking for visible scratches.11 JinkoSolar warns that cool water on a hot module can break the glass.8

The makers write the consequences into their cover. Trina: "Damages caused by failure to clean or improper cleaning procedures will void Trina Solar warranty."5 REC says pressure or steam cleaners, high pressure hoses, knives, blades and metallic sponges are "not permitted on REC panels and will invalidate the warranty".12

Lichen makes the temptation worse. A crust lichen is firmly attached to its surface by its entire lower side13, so it does not wipe off, and the obvious next step is a scraper or a harder brush. That is exactly the cleaning the makers rule out.

In plain terms The glass is the part that makes your power. A scratch on it does not wash off.

The roof around the panels

Lichen on the glass is a panel cleaning job, done to the panel maker's manual. Lichen and moss on the tiles around and under the panels is a roof job, and it is the same growth, fed by the same shade and the same water running off the glass.

On a roof with panels, the tiles are treated from ladders at the roofline, at low pressure, so nobody walks between the panels and nothing is blasted near them. That is the way the makers' rules point: both panel makers say not to stand on a module8, 5, and Monier warns that "Walking on roofs can be dangerous and may result in injury, damage, or void warranties."3 It also "strongly advises against the use of pressure washers for roof cleaning".3 More in why nobody needs to walk on your roof.

Growth moves back in from whatever is left. On the Italian sandstone, recolonisation after cleaning came mainly from the uncleaned surfaces around each treated patch.7 The tiles beside an array are part of the roof, and they need treating with the rest of it.

Trina also tells owners to clear vegetation and fallen leaves regularly so they do not shade the array.5 The same branches drop the leaves that sit in valleys and gutters, so one pruning helps the panels and the roof at once.

In plain terms It is weeding half a garden bed. The half you left is where the next lot comes from.

What this means for your roof

Lichen and moss on the tiles around solar panels live on the same water, dirt and shade as the lichen on the glass, and they are a roof job. We treat the roof with UNGROW Bailiff, our treatment, from ladders at the roofline, with a low pressure soft wash pump through non-directional nozzles, so nobody stands on a panel and nothing is forced under tiles or laps. We spray around the panels, not on them, while every face of the roof is covered, including the tiles around the array, so no untreated patch is left beside it to spread from. Growth recurs, so UNGROW Sentry, our preventative, keeps the roof treated after that.

Also asked

How do you get rid of lichen on solar panels?

With water and something soft, and nothing harder. REC's method: hose the panels at household water pressure early in the morning, while they are cool, then lightly wipe the growth with a soft sponge, microfibre cloth or soft brush on an extension pole, and rinse. Trina names a soft bristled brush too. A crust lichen holds on by its whole underside, so repeat the wash rather than reach for a scraper, blade, metal scourer or pressure cleaner. Work from the ground or a ladder, never standing on a panel.

How do you stop lichen growing on solar panels?

Take away the water, dirt and shade it lives on. Wash the glass regularly: JinkoSolar suggests about once a year, depending on the site, and Trina says panels laid flat need it more often. Keep the bottom frame clear, where wet grit settles and growth starts. Cut back branches that shade the array, as Trina advises. The tiles around the array grow the same lichen on the same shade and water, and keeping them clear is a roof job: how do you stop moss growing back on a roof.

Can I use a roof moss treatment on my solar panels?

Keep the treatment on the roof, and give the glass water and something soft. A roof treatment is made and labelled for the roof, and the panel makers want chemicals kept off their panels: JinkoSolar says never use chemicals on the glass, only tap water, and JinkoSolar and Trina both say to keep herbicides away from the junction box and connectors. That is why we spray around the panels with UNGROW Bailiff, our treatment, not on them.

Can Wet & Forget be used on solar panels?

On the glass, the panel makers ask for water and something soft instead. JinkoSolar says never use chemicals when cleaning its panels, because they may affect the warranty and the output. REC, writing about moss, mould and lichen on the back of its panels, says to clear the growth by hand or with a soft sponge, and that it does not provide warranty for the application of any sprays or treatment. Wet & Forget is an outdoor moss and mould remover, compared in the hardware store products.

Will the rain wash lichen off my panels?

Rain takes loose dust off tilted glass, and a gentle wash with water and something soft takes the rest. Growth that is attached stays through the rain, because a crust lichen is attached by its entire lower surface. On framed panels at a low tilt, rain leaves a line of wet grit along the bottom frame, where moisture and dirt collect for the next growth to settle, so that edge is the one to wash.

Should I get on the roof to clean them?

Clean them from a ladder or the ground, with a soft brush and water. JinkoSolar and Trina both say not to stand or step on the modules, and Monier warns that walking on roofs can be dangerous and may result in injury, damage, or void warranties. A brush on an extension pole reaches the glass without boots on the roof.

How often should panels be cleaned?

JinkoSolar suggests about once a year, depending on the site. Trina says panels laid flat need it more often, because they do not self-clean the way panels tilted at 10° or more do, and that leaves and vegetation shading the array should be cleared regularly. To see what the dirt is costing, Trina suggests measuring a soiled string's output, cleaning it, and measuring again.

Can lichen damage solar panels?

It can, through shade, and a gentle wash to the panel's manual is the fix. A patch of lichen shades the same cells every day. LONGi says partial obstruction may even cause hot spots, and Canadian Solar says power dissipated in shaded cells can cause localised overheating, which may shorten the module's service life. The makers' method is water and something soft, never scrapers, abrasive pads or harsh chemicals.

On the record

  1. Australian National Botanic Gardens, Urban lichens in Canberra
  2. Journal of environmental management, Microbial colonization affects the efficiency of photovoltaic panels in a tropical environment (2015)
  3. Monier, Roof cleaning and maintenance
  4. Frontiers in Energy Research, Characterization of Soiling Bands on the Bottom Edges of PV Modules (2021)
  5. Trina Solar, User Manual, Vertex Series Modules (UM-M-0002 PP7) (2026)
  6. Solar Energy, Soiling losses for solar photovoltaic systems in California (2013)
  7. The Science of the total environment, Lithobiontic recolonization following cleaning and preservative treatments on the rock engravings of Valle Camonica, Italy: A 54-months monitoring (2023)
  8. JinkoSolar, Dual Glass Photovoltaic Module Installation Manual (2021)
  9. LONGi, PV Module Operation and Maintenance Manual (version 02) (2024)
  10. Canadian Solar (CSI Solar), Installation Manual of Photovoltaic Module (AU), Rev 3.4 (2026)
  11. Trina Solar, User Manual (PS-M-0525), framed modules (2017)
  12. REC, Quick guide to cleaning
  13. Australian National Botanic Gardens, What is a lichen?

Get a price

Start with the address.

We price it off the address. No site visit, no two hour window, nobody walking through your house.

  1. 01You send the address.
  2. 02We look at the roof and send you a fixed price.
  3. 03To go ahead, tap Accept on the quote. We call you to pick a day.
  4. 04We treat it and photograph it the same day.
  5. 05We check it against that photo at twelve months.
  • Fixed price
  • Fully insured
  • 12 month guarantee

NOTICE TO VACATE

To

Moss, lichen, algae, mould

Leave by

Over the next 3 to 18 months

Evicted from the roofline.

Roof treatment · Western Australia